Repair control module of washing machine Indesit

[shapanqqccb]

Do not be lazy to do everything correctly, how long your washing machine will work in the future depends on it. If the bushing is in normal condition, but there is wear on it from the old oil seal, then the oil seal must already be selected so that its working place does not fall on the wear of the bushing. Bearings should be installed only by proven brands, for example SKF, there are also Japanese ones, but to be honest, I do not remember their name, since I only use the above-mentioned company. In short, greed in this case does not lead to good, if you do everything right, then your machine will work no less than a new one.

There are some control unit breakdowns that can be repaired by yourself, but basically, repair of this part should be done by a qualified technician. There are several articles on the site about repair.

Power supply repair - I draw attention to the fact that the breakdown oman telegram data is clearly visible here, and the control panel clearly indicates it, such a malfunction that I am talking about in this article is inherent in such a module as EVO 2, on Arkady and other units, things are a little more complicated
Strong jerks of the drum during washing - in principle, the difficulty is in changing the smd resistors, but it is quite possible to repair it yourself. As an example, the Arkady board is considered.
The washing machine fills and drains water - in this case, you need to change the two triacs that control the valves. The failure is typical for Arkadiya and EVO 2 boards.

You must remember that when repairing the control module, you take on a huge responsibility, the part is very difficult to repair and is not cheap, before you start repairing, think carefully whether the game is worth the candle. I refused a consultation about treating the control unit, it is impossible to do from a distance what I do in the workshop.